How would I connect this to a Pycom Expansion Board V3
@frankneufeld16674 жыл бұрын
How many sensors would you be able to connect like this?
@cristianobrito24634 жыл бұрын
Muito bom, dá pra fazer com mais sensores?
@williampowell75182 жыл бұрын
Do you know what could cause the temperature to not change? It does not give the new temperature until I reset/restart the board
@tamaragondwe8957 Жыл бұрын
did you figure it out?
@arunpatil79363 жыл бұрын
Hello, I am using this sensor. It worked fine for the first time but suddenly it is showing me a -126 error What should I do??
@arifbudiman64554 жыл бұрын
Ask sir..how to make a setpoint on the temperature sensor 1 for fan. sorry i'm new to arduino. please help me
@subbalakshmi7583 жыл бұрын
Can u tell me used items with details
@vamsikrishna-cr4xu4 жыл бұрын
hI sir, can u please tell me how to solve this error, as it showing msg : Exit status :1 'POSITIVE' was not declared in this scope
@mytectutor4 жыл бұрын
Please check the type of library you used for the I2C LCD.
@vamsikrishna-cr4xu4 жыл бұрын
Hi sir, Thank you very much for the rply. can you please tell me which library should I install. i have installed adafruit library. if it not that, please can you send me library. I searched in the description. it's not there.
@alifmohd73713 жыл бұрын
@@vamsikrishna-cr4xu i also got the same problem, i still dont know what to do