AD-S 30175 with Delem DA-66T Control This is a short video showing.. Basic Start-Up Procedure Details on Foot Switch Basic Shut-Down Procedure
Пікірлер: 12
@user-kg1ni7rc9b4 жыл бұрын
Лучшая в мире стойка, DELEM КРАСАВЧИКИ! 4й год на ней работаю, не нарадуюсь! 👍👍👍
@delwarhossain29774 жыл бұрын
I love DURMA machine. please make a video on crowning and calibrating the Y1 and Y2 that would be really helpful thanks.
@staffanoberg25382 жыл бұрын
If there are high surface finish requirements when press brake/edge bending, the Swedish product Tribotextil™ can be applied in the pressing/bending tool and mechanically protect the sheet metal from scratches and other damages. Tribotextil™ is an extremely thin and very strong textile that in this process replaces lubricants in the tool.
@delly415 жыл бұрын
I love to use this machine
@gregwinter35843 жыл бұрын
Great press, need to know how calibrate Y1 & Y2
@kingcuan52613 жыл бұрын
I’m a service technician for Australia’s durma dealer There’s a few ways to calibrate them If they are not bending same angle from side to side find out by how many degrees one side is out ie 3 degrees work out what three degrees is in mm movement be about 1-2mm then go into parameters and find the index point y1 y2 then adjust either side accordingly
@kingcuan52613 жыл бұрын
If they are bending same but not on target use corrections If waaay over or under folding get a piece of .5/.6 set machine to fold 180 degrees adjust y1/y2 index point in parameter until 180 fold basically pinches the material then returns back up with out leaving and crease machine should fold allot closer to target now 👍
@danieljhampshire73 Жыл бұрын
Got a new Durma and we’re trying to figure out how to set the shut height parameters on a program set up- any advice ?