DVP 14SS2 "Modbus RTU" DELTA MS300 VFD

[@reclusio]

For anyone struggling to make this work, you need to select modbus-RTU mode and 16 bit in the communication wizard, which for some reason is not shown in the video.

[@gilbertdevera3339]

Thank you for sharing this tutorial

[@AhmadShirzadi]

very good and thank you. good luck

[@machitthu6207]

How can i understand DTM function,sir?Could u mind if explain?

[@mdrobinislam6625]

Have any way to modbus delta sv2 to ms300 and sv2 to dopB07S411 rs-232 communication? I work this project. But in the same time the hmi does not work. But from pc, switchig work and motor on.

[@josefranciscovalentim2300]

Good Morning I always watch your videos and I have learned a lot from you! thanks. I would like if it were possible , if you have an example of a program with the ihm op 320 a with two or more frequency inverters I can also use it on screens from ihm op 320 to repeat example 1 on 0 off on the following screens or would have to actually match too many numbers. how would modbus and different addresses be possible in such situations on opposite screens since already thank you God bless

[@dharmeshsolanki7882]

I made same program same plc and drive ms 300 but not working

[@anku457]

please share plc programming file

[@ivanbratanov8699]

VFD command by Modbus is one of the easiest things. VFD could be controlled by DOP panel or DVP PLC. I have some projects made this way…

[@ChirayuBorse]

I've an issue in it ...... Can you help me solve

[@ivanbratanov8699]

@@ChirayuBorse what kind of issue?

[@ChirayuBorse]

@@ivanbratanov8699 im using as228p plc and ms300 series vfd ....... I need to enter (write) motor parameters such as voltage and current using modbus ...... But unable to do so because of lack of modbus address ....... Can you help me

[@dharmeshsolanki7882]

This program is not working

[@farazdeqnajim4205]

Ispsoft please .

[@fiifinenyi2156]

Hello sir