I also wondered about the tail wheel lack of directions. And yes... Those little tiny screws! Are you kidding me? Chinese guys have little fingers I guess. I have found the landing gear bends real easy if you bounce it. Also, you may want to replace the landing gear screws with M3x10 versus the M3x8 screws they give you. The extra 2mm's give you a bit more holding strength. Fun plane though! She bounces around on a windy day. It's pretty light.
@rcflyersofarizona81844 жыл бұрын
Thanks Capt. Bob I will look in to the screws. Your right its a few plane to fly and good looking in the air...
@rcflyersofarizona81844 жыл бұрын
Thanks Capt. Bob so far so good on my landing but I will keep it in mind
@WildBillFlysRC4 жыл бұрын
where do you fly at? cool plane!
@rcflyersofarizona81844 жыл бұрын
in the south Chandler Area
@WildBillFlysRC4 жыл бұрын
RC Flyers of Arizona I’m in Marana AZ ✌️
@BUXdavidbuxkemper4 жыл бұрын
The screws on the rear struts sucked. Bet I dropped them 10 times
@rcflyersofarizona81844 жыл бұрын
me too!!
@drfiberglass4 жыл бұрын
I used a small pair if needle noise pliers to get them started... Got to use tools sometimes.
@drfiberglass4 жыл бұрын
What kind of camera did you use on the plane ?? Thanks..
@rcflyersofarizona81844 жыл бұрын
sorry for not getting back to you so soon. I use a Mobius and a runcam I got both from Amazon and they are made for RC so they are very light. about $70.00 each