E28Goodies M20 Turbo Manifold Fitment Guide with Measurements

[@sean.d7171]

Its a good looking manifold looks like a factory m spec made for it and will last way longer than header type can't wait to see how these mods go.

[@frnklwrnr29]

Looks way better than the cxracing manifold.

[@ok.944]

Not really sure where to leave this question. I used your videos to learn how to tune, they were very helpful, thank you for uploading them :) . I don't think I could have done it without them. I'm trying to implement launch control into the car but the factory clutch switch is closed, so when the clutch is out the signal goes to ground. So with it wired into the ecu it activates launch control activates when the clutch is out. I guess what I'm trying to get at is whether or not I can make the ecu look for the open switch to activate launch control or to look for the closed circuit to deactivate launch control. I'm not normally one to ask questions, I just try to find the answer but I couldn't find anything on the subject.

[@TurbineResearch]

I had the same situation in my car with trying to use the factory clutch switch. I ended up just finding a switch on eBay that fit the factory switch mount and used one that grounded when the clutch is pressed. I wish I was more helpful but I just changed this switch on mine

[@ok.944]

@TurbineResearch I swore I was one of the only people with this issue since nobody else has post on the forums. You would think tunerstudio would have a configuration for the switch lol.

[@michaelriccardi424]

Just ordered a kangaroo manifold a few mins ago, super excited to get it installed. Is the 38mm gate enough to prevent creep at low boost?

[@TurbineResearch]

Previously we had a 38mm wastegate on this engine with no problems with boost control

[@john9427]

Have you seen it on a e30 yet? Any issues you can think of?

[@bloever1234]

I am runnin it in an ix no problem.