E36 Door Lock Cylinder Removal & Installation (swap) - Key is Required

[@andrewgoodbody2121]

Bro has the best voice, especially for good boy borks

[@Thewiz666]

What is done about the older lock cylinders to go in the newer style? Replaced the handle on my '95 with a fresh one and the lock cylinder wouldn't fully insert into it so I've been having to run it like an older Chevy with a door key and start key.

[@jakubkeclik9589]

Facing this issue right now. How dod you tackle it?

[@mrvanable]

@@jakubkeclik9589 get a new style handle I think is only fix, for some reason my 325is had one new style and one old style the new style is a pain in the ass without the key to remove the tumbler. But I’ve got an old style one and was unable to fit the tumbler and get it to lock in as the hole for the roll pin is a different size… let me know if you figured out a way haha..

[@onesikm3]

@@jakubkeclik9589did you resolve this ? I’m pretty sure we need to buy a new style lock cylinder and then install the waffers and get the keys to match. The waffers isn’t too hard to figure out but you can have a locksmith install them for you. I’m going to buy mine at the dealer or atleast go to them to request the lock code since those wafers are numbered 1-31

[@Thewiz666]

@@jakubkeclik9589 The trashy 2 key solution is still it. I'm not in a place where I can leave the car without a door handle for the time it'd take me to truly get it addressed properly.