E550 VFD Parameter Settings & the Fu.13 Error Code

I walk through the process of programming the E550 VFD from Automation Technologies Inc.
This video is for those that run into the error, Fu.13
Your Hz value is programmed incorrectly.
Visit my Design Concepts blog to read about the stuff I am currently working on.
designconcepts...
Here's a list of the services that I offer
designconcepts...

[@ronnieryals8243]

Thank you very much for sharing this information. It was of great benefit to me.

[@TylerHarney]

I'm glad I could be of help!

[@ronnieryals8243]

The spindle lurches, or jumps, a bit when I turn the spindle on. This causes my closed loop stepper motor to lose step and go into alarm mode. I have to cut and restart power to clear the alarm. The problem repeats again when I restart. I have programmed as your video which corresponds with instructions from cncp4cc. I have the same spindle as in your video. Can you offer any advice?

[@chrisf8584]

Doing a bit of research on this VFD. When you hit the shift key

[@naninani5840]

Hello bro , l have got same problem but in case of showing error code (fu.13) it's showing error code (fu.37) please tell me the reason why it's showing like that

[@jesolitojunio4074]

The spindle sir is work if I push to a parameter and if I play to mainboard is not working and how I fix sir?

[@mahadevstonedesigningbalot948]

Fu 03 error?

[@TylerHarney]

Check the load: The error might occur if the load is too large. If possible, reduce the load on the VFD . Adjust the acceleration time: If the acceleration time is too short, it could cause the error. Try extending the acceleration time . Check the torque boost: If the torque boost is set too high, it could cause the error. Try reducing the torque boost . Check the power voltage: The error could occur if the network voltage is too low. Ensure that the power voltage is at the correct level .

[@jesolitojunio4074]

How to connect that one to main board

[@jesolitojunio4074]

Hi sir how about the spindle not run

[@benbenameur8429]

hello you dont set current output ?

[@TylerHarney]

I was never able to find that setting on the VFD.

[@kodurukishorebabu4626]

Hi sir FU 37 error please solve sir

[@jesolitojunio4074]

Hi sir how about the spindle not run or rotate

[@TylerHarney]

Did you ever figure this out? Does it make any noise when you push star/run?

[@jesolitojunio4074]

@@TylerHarney no?

[@jesolitojunio4074]

You have a WhatsApp sir I sent the video for my machine happened

[@jesolitojunio4074]

You have a WhatsApp sir?