AutoCAD 3D, bolt and nut drawing, autoCAD training

[@pramodmyakal6875]

please add your voice also somethimes things are not understood

[@bpetnoi1472]

I believe you did much more work than necessary. I would have made a copy of the bolt and placed it on the nut. I would then use subtract to remove the bolt from the nut leaving threads on the nut. Much easier than making the threads on the nut.

[@mghvinjilia]

Sir! Why do you use a triangle two times, one on the bottom and another on the top of the helix to sweep. It would be enough one time?!

[@Eangsopheann]

because of the top one for make thread and buttom to make thread end smooth and look nice.

[@s.j.graphicsdesignaccounti5340]

i love it you are the best designer

[@douglasvieira1824]

Thanks. Good job!!👏🏼👏🏼👏🏼👏🏼👏🏼👏🏼

[@Eangsopheann]

thank you

[@IvanJest]

when using the sweep command, the triangle turned out to be only at the bottom, but not at the top, why?

[@Eangsopheann]

i am not clear about you question please again, Thank you

[@zeezoo6174]

nice viedo :) keep up the good work

[@s.j.graphicsdesignaccounti5340]

please sir ji make a drone, table fan, celling fan, sofa, table, chair

[@ankitrai2266]

Add voice bhai sahab

[@umarrider3332]

If we draw a window in 3d in a specific dimension. But in our project windows dimension not same. Can we insert Windows without making a new window with new dimension.

[@halimkhan8789]

wonderful

[@weishitang4683]

对我有启发！好。

[@Lussacregan]

If you can't say a word, it's not a tutorial, I think you reposted someone's video, editing just clicks 👎

[@Eangsopheann]

yes, i had new share video have sound, thank you.