Echo 2511T ported: Setup, R&D, and cut times comparisons

[e-mail]

[@yotaismygame]

Looking for customers who want a ported cylinder for a 2511t. See my tear down video for more details

[@Houseworksaws]

Seriously awesome video dude.. incredibly informative without a bunch of crap

[@yotaismygame]

Matt DigginNH That was the plan.

[@billylacount6608]

Just the info I was looking for. Great work!

[@yotaismygame]

Billy LaCount Thanks glad to hear that.

[@jimmymiller5776]

Well done

[@TimberTrainer]

Try 3/8 narrow kerf if you haven't already. I highly recommend the Oregon 90px for the 2511. You will need a bar, but keep the 3/8 sprocket. The carver eats up a bit of power, but is nice for finer pruning.

[@tbabajan]

Would love to see some more vids on the actual porting process. Might take away some of your clients but I'm sure lots of people would appreciate it! haha

[@yotaismygame]

Trevor Babajan basic stuff. Widen and polish. Drop the jug, advance the timing. Tough to get into the little guy.

[@tbabajan]

Saw Greater no clue what drop the jug means though, lol.

[@yotaismygame]

Trevor Babajan requires a lathe. This is more than just opening stuff up. It’s full blown porting with all new port timing numbers. Most people don’t understand any of that.

[@tbabajan]

Ahhhh so this is legit ported then, lol. Not just giving it some better air flow.

[@yotaismygame]

Trevor Babajan yessir

[@turbokingcab]

Where did you find .325 sprocket for the 2511? I only finds 1/4" and 3/8"

[@mikefleming660]

I found adjusting the carb after doing the mods seems to be a bit more difficult than a normal carb. I removed the limiter caps but still tough to adjust. doesn't seem to be the normal style of carb. Did you have difficulties adjusting?

[@yotaismygame]

I agree. After porting it works like normal. But when stock adjusting does almost nothing

[@bethanyhaskiell9116]

Thinking of getting a Husqvarna T525 do you still do porting if so I would like to get it ported

[@broadwayline]

Did you ever try stock timing?

[@yotaismygame]

broadwayline I can look back at my notes

[@broadwayline]

Saw Greater thanks man - I just watched your full video super good stuff - how do I contact you for port work?

[@yotaismygame]

broadwayline [e-mail]

[@gerbutt]

Hello dude, great vid and info 👍 I’ve got a little vid of mine with just an exhaust mod and the stihl 1/4 bar and chain setup, see what you think 👍

[@yotaismygame]

gerbutt looks like it cuts good. Would have been nice to see more cuts to make a better opinion on it. I went pretty conservative on the porting on mine. Also every chain I’ve ran on it was stock. I could get more out of it with better filing. Same with break in time. People seem to say after four tanks it starts to come alive. Only on about two.

[@Idiot1477]

You oughta check my 355T I ported pulling an 18" SC... Unless ur on any of the Facebook saw pages ..... Then youve probably already seen it 🤦🏻‍♂️😅

[@toddjensen7816]

Coleby can I get some info on the 355t

[@chrisevansgardenservicesjo8093]

Chain is blunt

[@yotaismygame]

Not even a little bit

[@JohnAllen-lw7xf]

Walnut doesn’t play lol. great video