NC normally closed means after the time delay ends this connection will turn off cause it becomes open and NO gets connected after time delay ends
@obioraobi1942 Жыл бұрын
2:58 I can't find the video to learn how to connect the normally open and normally closed timer 😢
@shozabhaider-lv6efАй бұрын
hey africans how are you
@davidbrits24329 ай бұрын
Ok how would you wire one of these geyser timers in with a Load Control relay between geyser and stove?
@elliotndlovu556 Жыл бұрын
Very helpful
@RuanOrjustRu10 ай бұрын
I want to install a timer that stops all mains power to the system during the day, but allows at night. My solar produces enough electricity during the day, but I want to set this to SUB priority and switch to mains from 10pm to 5am so I can run the geyser on mains at 4am and on sun during the day.
@bonganiedwardmthethwa6455 Жыл бұрын
Hi, thank you for the excellent video. I just need to know if, can I use one time to run two geysers?
@ecologicaltime Жыл бұрын
Thank you. No that would over load it
@steveenslin38422 жыл бұрын
Hi. If I run a second DB board i a lapa from the home DB I am doing it from a 25 Amp breaker in house main DB to 60amp 5 breaker DB in Lapa. But I think this is not correct as my jacuzzi 32 amp breaker trips and gets hot when 4kw heater kicks in. What coule be reason for overheating. When i disconnect the heater there is no heat to the breaker and it runs fine
@robinhlatshwayo159111 ай бұрын
Can you use the 1.5mm cable for stove also as long as you have put it to its on circuit breaker?
@keveshannaidoo56702 ай бұрын
No
@geniusmarcsays24342 ай бұрын
when you say 4 mm, are you saying the diameter or area? like 4 mm square?
@ecologicaltime2 ай бұрын
usually when you order wire we just say the number not squared but yes technically its squared.
@senzocele7036 Жыл бұрын
How to connect more than 1 circuit breaker on timer
@derrickmorris48012 жыл бұрын
How do u put it on bypass
@tshupetsomonedi2 жыл бұрын
Can you show how to wire a timer on a double pole breaker? 🥴🥴 I bought a timer now I don't know how to install it.