ECU REPAIR TIPS (part 6) ujanja Establishing the, Data & Power Lines!

As we fully discussed, the ECU's behavior due to VCC1 at the front module being of overvoltage is different, compared to trigger failures. So, including all the voltages, 5V, 3.3V, 3V, etc, all better be catered for!
In order to avoid device damage during debugging or programming of the ECU, it is recommended to handle the ECU in a “controlled” production environment to ensure hakuna tatizo!
If this cannot be ensured, that standard resistor resistor between FO3/TEST pins and the connector ni lazima!
On www.5021.tips/u... as You download the whole jogolize bump, on chapter 4 of the input module, take all so you compare!
#5021Tips #onlinecourses #hapaujanjatu

[@sujarwoko8431]

what is the price of ic data set, ecu circuit diagram, ecu connector wiring diagram, for ecu master electronics service

[@enockmakule5862]

Nahitaji niungwanishe kwenye group leni nijifunze