Educate....Shout out for a great channel and learn that Sheet Metal is Fun

I love learning and I came across this channel which is about "Sheet Metal is Fun", I hope you enjoy this short video and follow my suggestion... go to Ken's channel

[@rexmyers991]

Thank you, Sir

[@derinteriors]

Just spent the afternoon watching all his videos. Thanks for sharing 👍

[@kimber1958]

Very nice thank you for sharing

[@kengodfrey1956]

Dang Chuck i just watched your shout out to us! That was awesome for you to enjoy and apply something we put together. I believe the best way to learn is to teach. And I'm still learning. Thanks again.

[@outsidescrewball]

Thanks Ken, my thought was to increase your subscriptions to your GREAT channel....best, Chuck

[@swanvalleymachineshop]

👍👍👍

[@AmateurRedneckWorkshop]

Oww Chuck you made my head hurt. Thanks for the video keep on keeping on.

[@dannywilsher4165]

Good one. Thanks Chuck!

[@patrickbeaumier8616]

Nice trick ❤

[@acedavis4247]

I just found him and have been watching intently Thank you so much for sharing You put out such great content Thank you for your time and efforts

[@CameronMcCreary]

I first started really learning about sheet metal when I was making bending and forming fixtures / jigs for cartridge magazines when I was working for John Martz the Luger carbine maker from Lincoln, California.

[@donteeple6124]

Chuck, You did good with this one.....WELL explained and demonstrated...even those that still use fingers and toes methods will understand....BRAVO !!!! Don

[@MyLilMule]

As an American, you are convincing me that metric is better. 😂

[@Bobs-Wrigles5555]

Good video Chuck, but wait till you discover the power of 3.

[@outsidescrewball]

ok...you got me...pls explain...

[@Bobs-Wrigles5555]

@@outsidescrewball It can be a lot of things, and these are just two examples. Example one, if you mark 3 points on the circumference of a circle that you don't know the center point of, and draw lines from one to two then two to three, measure and mark the middle of each line and draw a line at right angle from those two middle points toward the inside of the circle, where they intersect is the center of the circle(good enough for sheet metal work). Example two (good party trick) Get someone to choose a whole number that they know is divisible by 3 and get them to add each of the digits of the number together, if they get a number that is higher than 11, tell them to add that number's digits together, if they still have a number higher than 11, tell them to repeat the additions, they Will get a number that is divisible by 3 and will be either 3, 6 or 9, If they Don't then the number will be a Prime number divisible by itself and one only. eg 241233(/3=8411) becomes 2+4+1+2+3+3=15>> 1+5=6 (divisible by 3). I loved math when I was younger😏

[@barrygerbracht5077]

and this is why metric was invented....

[@chrisstephens6673]

Forgive an old fool being facetious but dont you americans get taught maths in your schools? 😅😅😅😅😅 But going by past recommendations, joe pie etc, I'll take a look.