Electric Baseboard Heat Install with ecobee smart Thermostat

[@johngrimble3050]

Finally, a really good video on how to wire this thing 🙌. Thank you very much!

[@DownToTheFrame]

You’re most welcome!!!

[@cedricbelmont5499]

This is the best (and only) video of someone explaining the whole process for installing a new thermostat. I was so tired of watching everyone just replacing a thermostat and acting like they were the second coming of jesus . THANK YOU and keep doing what you're doing.

[@DownToTheFrame]

haha love this comment! I am glad you found it helpful! Thank you and I will!

[@DoubleD603]

Great video as always!

[@DownToTheFrame]

Thank you buddy!

[@andrewclarke3622]

Its been a while since ive been around baseboard heaters. I remember them being slow to heat. But the quality is quite stable.

[@DownToTheFrame]

They did a much better job evenly gradually heating than our original propane system and it is so quiet!

[@andrewclarke3622]

I grew up in Michigan, currently living in California. I dont like the kind of furnace you replaced. You definatly could tell when it was running. Roasting everyone nearby. When I moved into my first apartment, it was heated by steam. I think radiant heat is more comfortable.

[@malcomflot2288]

Thanks man. Always! You're a genius.

[@DownToTheFrame]

You’re welcome! and thank you!

[@erinsullivan2727]

Good job.

[@DownToTheFrame]

Thank you!

[@Richard-C]

great video,keep up the good work 👏👏👏👏👏👌👌👌👌👌👍👍👍👍👍

[@DownToTheFrame]

Thank you!!!

[@noshirpanthakee]

Awesome video! Do you know if the relay you used would be good to run multiple baseboard heaters from? Like if instead of 2 baseboard heaters you could run 4 or 5 to that same thermostat? Same process?

[@DownToTheFrame]

Great question! Personally, I would ask the manufacturer. However, from an electrical stand point it can hold as many baseboards as 20amp amps will allow. So if you have 5 baseboards who’s total 125% amperage is less than 20amp then theoretically the relay will be fine. You just need to wire it in a junction box like I did in the video

[@jeffersonavelino]

Hey bud what type of wiring u used for 240 base board heater.

[@DownToTheFrame]

I used 12/3 because of the calculations I did told me that would be the correct size. I could have also used 12/2 but I like have a neutral wire going to every junction point.

[@anrivera1975]

How much electricity these baseboards pull per month?

[@riar7932]

Mannn great video! I wished I could pay you to do my house.

[@DownToTheFrame]

Thank you! Honestly I wish I could too! haha

[@JeffBannister-g6c]

89