Electric Guitar Action DONE RIGHT! | Guitar Setup Pt.2

Learn some tips and tricks around adjusting the action on your electric guitar in this tutorial.
Before following this tutorial, be sure to check out Part 1 of how to setup your electric guitar, starting with the truss rod:
• How to Adjust the Trus...
#guitar #restringing #tutorial #guitarreviver

[@AdlerNicolas-l1l]

Clear Direct & Simple no time wasted now I have to back to the Setup Pt.1

[@NEONNOONE]

I was searching for this kind of video to forward to my beginner friend. This is hands down the best one. Great job, informative and on point!

[@robertbaldwin177]

Great vid, if you are down at 2mm on low E and 1 5mm on high e, but you are getting fret buzz do you raise bridge saddles higher, or adjust truss rod? I have this issue on a cheap beginner guitar and suspect its the poor guitar at fault.

[@pflakes5497]

Do I have to keep retuning to maintain the trem gap? Thanks

[@GuitarReviver]

I personally dislike floating tremolos so I tend to add between 3-5 springs in the back and screw the two trem claw screws as far into the body as I can, this keeps the tremolo flat to the body even when all 6 strings are tuned up to pitch. Hope this helps!

[@persiaguitar]

When measuring your action did you put a capo on first fret ?

[@GuitarReviver]

Thanks for your comment. No, I don't use a capo at all when adjusting action, however I do use a capo at the first fret when checking the truss rod adjustment.

[@persiaguitar]

5 months ago I asked the question. my set up is all over :) LOL@@GuitarReviver

[@GuitarReviver]

@@persiaguitar well now you know for next time ;-)

[@persiaguitar]

thanks a lot @@GuitarReviver

[@aftabahmad-yr9ys]

switch off the stupid F music in the background

[@LetItbe-d2p]

hhHhaha