electrical box stamped in progressive tool

[@tosifahmad8862]

Great work by great people

[@santoshpatil2082]

Good job

[@kartikgandhi2209]

Hello can u tell what do you call that tray at bottom of mould to remove scrap

[@townnet]

Hi, what kind of the situation you have to design the stripper at lower and the Die at upper?

[@bharatlunia2056]

Hi, how much total cost this production line press tools and machine please reply,

[@chitanya4u]

What will be the approximate cost of this stamping machine?

[@ujwalgulhane3576]

The Box design is rather unusual. I see bar type lifters. When do you prefer bar type over round pin/post type lifters ( I see them in many progressive dies videos)? Your videos are always well-shot. They offer opportunities to learn construction and design for learners like me. How long does it approximately take to build a tool of this type?

[@prectoolandstamping]

Yes, we like to use the bar type lifters if there is enough room. The bar type lifters, when they are on the edge of the strip, also allow us to add a top lip to capture the strip in a small slot (the strip rides in the small slot milled down the length of the bar lifter). This tool took 12-14 weeks to design, build, and get a part off the tool that was within part print specs. Thanks for commenting!

[@rollformer5660]

good design

[@bhanupratapsingh-xt2wl]

well done.

[@prectoolandstamping]

Thank you!

[@phoebeyang564]

Great !

[@sarathraj99]

how to setup this machine...

[@zoltanvoros1837]

NIce.

[@shaiksalmansalman4469]

I want work