Elegoo Neptune 4 Max - Watch Before You Buy It

[@TheOpinionatedYouTuber]

I just found your video AFTER buying and setting up my Elegoo Neptune 4 Max. I had a Creality Ender 3 V2 that died. I have experienced the issue where when you select a new print, the preview doesn't come up. Rebooting the printer fixed this issue for me. I have beej printing literally non-stop since I got it this past Monday and so far so good.

[@srchevere4136]

Hi, I'm thinking about buying this 3D printer. I have a question for you, is the printer still working without errors?

[@raymondturpin3265]

Must let it heat up for about 20-30 minutes before leveling because the bed warps up and down while it heats up. After time it will stop moving and you can get an accurate leveling.

[@3DPrintsBuilds]

Yes, that helps.

[@dunnoboah]

This is a major design flaw and is honestly putting me off buying it

[@raymondturpin3265]

@@dunnoboah All large beds do the same thing

[@Thebeardedviking865]

I just got mine and running my first large print through it. Shall see how she holds up.

[@gadgetro7184]

How did It go? Im thinking of buying one in the future but ive seen so many negative reviews and im a bit scared :(

[@srchevere4136]

@@gadgetro7184 Hi friend, I'm in the same situation. I need a review of the printer after having used it for a long time.

[@eliasYC]

Does it work well with OrcaSlicer?

[@desktop3d]

Do you plan on making a video using the dual extruder and a full bed print with this printer?

[@3DPrintsBuilds]

This printer has dual-gear direct extruder. I don't think it has option to add second extruder or what do you mean about dual extruder. I have done big prints. You can see it in my other videos.

[@desktop3d]

@@3DPrintsBuilds I was asking about a big print on this printer, specifically. At 4:20 you said the nozzle was too close on the edges and at 4:38, after updating the firmware, you said the printer was not level for printing big models.

[@3DPrintsBuilds]

@@desktop3d The problem was also before the update. The update didn't change anything. To get better results printing big prints you need to preheat the bed about 20-30min then auto level before every print.

[@desktop3d]

@@3DPrintsBuilds I would need to see a full bed print with two colors on this printer before considering to buy it. Thanks for the video!

[@alex25ru]

where are you from brother?

[@Crims0nMakesStuff]

How has the printer performed so far after this video, any major issues?

[@3DPrintsBuilds]

It works fine, no new problems have appeared.