Enabling Local/Remote Button on Altivar ATV 630/930 Process Drives | Schneider Electric Support

How can I configure an ATV630 to sendo me Current and other status (Like Profibus Address and Motor Nominal Speed) through profibus DP? I'm using Telegram 101 and the only things I see /send are RPM and discrete status/commands. Any video and/or manual? Thx a lot!!

[@jonolitan4698]

Hi, how do I make run enable in the terminal, I mean to start-stop the motor. Because on the Local I can manually set the frequency, but in terminal/Remote I have the reference frequency in AI3 and Channel 1, but do I need a reference in DI to run enable the motor during in the Remote? Please provide me an advice, i appreciate it, thanks.

[@germansanguinetti]

What are the differences between the two options: [Bumpless] and [Stop] ?

[@schneiderelectric]

Hello German! The following Schneider Electric FAQ explains these differences: www.schneider-electric.us/en/faqs/FA282739/ Thanks for your question!

[@germansanguinetti]

Schneider-Electric Thanks for the answer. Same as in Programming Manual. Stop or not stop the drive

[@rullyaljiansah6656]

how to fix internal eror inf3 ?? thanks atv630

[@jasimnc7056]

can i get control wiring diagram

[@areyankhanna2159]

ATV 640 giving DC bus over voltage how to solve

[@schneiderelectric]

Please check out the following FAQ: www.se.com/us/en/faqs/FA305478/ If you still experience issues after reviewing the content, reach out to your local technical support at www.se.com/ww/en/work/support/country-selector/contact-us.jsp.

[@victorpajares7126]

pongalo en español, por favor

[@ADiBloggers]

Esta bien