Ender 3 Upgrades

[@KrazyDayz82]

Is the extruder hitting the stop end switch?

[@Mickwild562]

@KrazyDayz82 yes the extruder is latching on the x axis limit switch perfectly. I need to make a adjustment within my ender 3 machine settings but not sure what or where to put the figure. My CR touch is around 54mm from the limit switch and around 47mm from my hot nozzle on the x axis.

[@KrazyDayz82]

@ hi, goto configuration, advanced, you should see X Y Z probe settings, adjust to bedsize, Write down current settings.. no dramatic adjustments

[@Mickwild562]

@KrazyDayz82 I will try that later. I will let you know the results. I am still a little apprehensive about this printer until I get to know it. I can't do that unless i start tweaking it and trial and error. Thanks for the advice, I'll keep you posted 👍

[@Mickwild562]

@KrazyDayz82. Managed to sort the axis issue out. Thanks for your advice 👍 kzbin.infoqe1120s1Kcw?si=A4THWzKvErp4WpaL