What you get done to it big dawg?? I got a 97 Crown, damn near amazing condition. Monday I’m going to drop off at shop for two weeks. They’re gonna replace timing chains and every gasket in the engine. Clean engine and clean engine bay. When I pick her up sure going to get painted!!! No lie, you motivating me to make a lil channel and start showing off this work! Keep doing what you’re doing playa 🫡 ✊🏾
@topiqchill2415 ай бұрын
Engine Overhaul with slightly bigger pistons heads reworked with heavy seals and gaskets . I built it for some speed but mostly durability
@molarguy5 ай бұрын
Disconnect the canister purge valve and watch vacuum. Disconnect the lower hose to the valve,if the problem, then drive it and test.If you don't disconnect line to gas tank system could cause tank implosion. Might be a mess of rotting rubber and carbon lines your working may have triggered.The simple wire disconnect will tell@ idle if the problem. Free easy test. Occam's Razor.
@molarguy5 ай бұрын
Translate: by pass EVAP.
@budwashedit5 ай бұрын
🔥🔥🔥🔥🔥
@TRIPPIE_OTX5 ай бұрын
🔥🔥🔥
@ruddystamps34895 ай бұрын
I see you fam finally got the merc back and it’s sounding dam good they did a good job yessir its about to be some fire content coming 💯💯💯💪🏾💪🏾💪🏾💪🏾
@topiqchill2415 ай бұрын
Yes sir bro once I get this misfire out we will have motion
@budwashedit5 ай бұрын
Raw and uncut
@King_David895 ай бұрын
Had that same issue some years ago and it was a wire for one of my fuel injectors had a short
@topiqchill2415 ай бұрын
Exactly it’s something on the wire harness I figured it out stay tuned. Will be showing you guys what the issue was💯💪🏾
@jaysonwilliam8505 ай бұрын
Hopefully you figure it out and get it right
@topiqchill2415 ай бұрын
I will figure it out bro no cap it’s something very simple all cylinders have 150 to 155 pressure reading. Head sealed tightly everything a1. Stay tuned