engine run stand episode 1

[@randallmckay4315]

Could you possibly give me the height and width please… AWESOME JOB

[@michaelstreet6006]

It's probably good the Corvette is so dusty. I betcha it's covered in overspray. Been der, done dat. The stand looks like it'll work until you rev the engine too hard or if it won't idle right. Maybe a wider wheel base? IDK. My two cents.🤔

[@papergatorzfedducca7998]

New subscriber!!!!!

[@ccmasonry1125]

The trick is put the engine stand in backwards then you’ll be able to connect your engine to your stand off of your hoist same thing with taking it out and putting it in I found that to be a lot easier

[@gordonsgarage1845]

i will look into that. thank you

[@redneckswitwheels]

​@@gordonsgarage1845 never had a issue mounting my sbc this is funny 😅

[@randallmckay4315]

The test panel

[@classicstangbrn8964]

Why do you need a keyed ingtion switch?

[@gordonsgarage1845]

Good question. I have no idea. I found it laying around the shop and went with it.

[@tonymontana897]

Use what you have usually. Why spend money on stuff when you can use what's laying around.

[@Amxracer]

😎