Рет қаралды 5,278
This is the last 3 parts of the Sam maloof Low-back Chair production process.
As much as possible, I tried to make it according to the method in the video (DVD) for making the Maloop chair.
00:00 start
00:50 Mark the area to be removed
02:49 Backrest end grain pattern drawing
04:15 Router work (Roundover bit (R15.9) in the lower part of the back of the seat plate)
04:29 router operation (Leg, roundover bit (R19.5)
04:58 Armrest power carving (4 inch 24# sanding disc)
05:51 Backrest power carving (4 inch 24# sanding disc)
05:56 Hind leg power carving (4 inch 24# sanding disc)
06:06 Seat power carving (4 inch 24# sanding disc)
07:48 Power carving for the front leg after provisional assembly (#24 sending disk)
08:12 Armrest and hind leg power carving after provisional assembly (#24 sending disk)
08:48 decomposition
09:13 Seat side router work
09:21 Seat power carving (4 inch 60# sanding disc)
10:07 hand carving
11:06 Assembly
13:49 Display the power carving position after assembly
14:35 Power Carving
16:17 hand carving
18:21 Dowel pin making & Dowel pin work
21:03 Watering the burrs to rise
21:21 one day later
22:04 Leveling the legs
23:40 Finishing (Osmo Forix Oil 3032)
#SamMaloofLow-backChair
#LowBackChair
#ComfortableChair
Advice and suggestions are always welcome.
If it helped a little
Please "Subscribe", "Set notification" and "Like".
▶ youtube "enjoying woodworking" Free Subscribe
bit.ly/2LI9Apt
BGM :
* KZbin Audio Music Library