error 109 roland BN 20

[@alexbuggs-vf1zf]

Can you redo the video and explain what you're doing

[@MarkP635]

Well, it resolves only for a short period of time. Try checking THE GEAR on the motor connected with the felt and wiper to turn around.. that was the problem in my case! The scraper, underneath, had to replaced because it was bent. Good luck!

[@acwright28]

It worked 🙏 for this

[@missy1e23]

Ive taken the 3 screws out, but another video said there were 5 screws. I cant pull the platr out to expose the wiper area. Where are the other 2 screws? Or are there 2 more screws?

[@JimmyAbeyta]

DID YOU GET AN ANSWER

[@missy1e23]

@@JimmyAbeyta I found the other 2 screws. They are on top of the plate, but be careful not to unscrew a different set of three screws. I had to use a kinda long screwdriver to get to the screws without bumping my hand up against the inside of the printer.

[@BeardedFreak85]

@AZTRAL PRINT mine fixed the issue and i can print, but every times it turns on again from sleeping i get the same error and have to open the printer again and move that little lever. Any suggestions? already cleaned all the area but still having issues

[@miguelangelquintero4906]

Hi, I'm from Mexico and I got the same error if it can be repaired or you have to buy the part as they have solved it, greetings.

[@foundrylabz]

So the cause of the error is that relay switch there? I wonder if you can just order the part for it... Check the part number and maybe on amazon you can find it.

[@miguelangelquintero4906]

Hi, I'm from Mexico and I got the same error if it can be repaired or you have to buy the part as they have solved it, greetings.

[@kylebaptiste2523]

Why not talk and explain it step by step? This is little to no help