Concrete truck transmission repair. RTO16909ALL Eaton Fuller. Part 1

[@nickwoop4153]

I like your home made hook to lift out/in the shafts :)

[@etrtruckcenterenginedrivet8918]

A good family friend made it for me he used to build a lot of the old rto9513

[@salomonvargas7036]

Muy. Bueno

[@LancelotMasunda]

Thank you bro you a master . I have learnt a lot

[@etrtruckcenterenginedrivet8918]

Happy to help

[@sabetteia710]

Thanks for the nice job

[@etrtruckcenterenginedrivet8918]

Thanks for the comment and thanks for watching!

[@heartobefelt]

at 14:17 you fitted the flange , Isnt there a rotary shaft seal to go inside that flange to stop oil leaking past the input shaft ?

[@etrtruckcenterenginedrivet8918]

No sir the input shaft has reverse spirals cut into the shaft that when the engine is running pulls the oil back into the case. There is however a shipping seal located there from the factory it is not needed during a repair or replacement of the input shaft. The shipping seal does nothing but keep oil from leaking past the input shaft when the transmission is in the vertical position during storage.

[@heartobefelt]

@@etrtruckcenterenginedrivet8918 Thankyou Sir :) Been watching videos to see if i can learn enough to rebuild a 9 speed which wont downshift 5th to 4th , Many experienced mechanics dont attempt to repair these transmissions , They tell me "Send it out" ;)

[@gagemacdonald3807]

What’s the part number for the shift fork bushing driver?

[@blinky470]

Where u guys located

[@sabetteia710]

I have a 10 speed eton the module start to leaks air I called mechanic for which Chang the module 2 times but still leaking air around bottom plate and it is not getting in gear what is your advice on it

[@etrtruckcenterenginedrivet8918]

The top plate is bad watch our video on fro top plate water damage

[@etrtruckcenterenginedrivet8918]

Your top is going to be rusted out on the inside of the range cylinder

[@sabetteia710]

That’s I will watch it

[@BB-lm7cs]

For those LL transmissions I would always put in both counters without bearings, and then flop in the mainshaft. It gives plenty of clearance around that big low gear and it's not hard to pop in the countershaft bearings after the fact.

[@noelnoel4916]

How much to teach me how to rebuild Eaton fuller 13 speed

[@etrtruckcenterenginedrivet8918]

Contact me on Monday

[@noelnoel4916]

@@etrtruckcenterenginedrivet8918 thank you