Just the video I was looking for, thanks. Where do you purchase the pre expanded beads?
@rasmalai2426Ай бұрын
How to color this ball you made? Please do a video. Thank you
@hydroponikstuttgart45157 ай бұрын
Hey, great Video! Could i bake my mold in a oven if i premoisture my eps beads? Thx, Cheers
@andreyl2705 Жыл бұрын
Thank you. very useful.
@splendour3951 Жыл бұрын
Thanks 🙏
@charlesweinberg98029 ай бұрын
Hey there, Where are you purchasing the beads from?
@toastrecon Жыл бұрын
I wonder how much outward pressure they exert when they expand. Could you make the mold out of plastic?
@EPSEPP10 ай бұрын
It depends on various parameters, In my working place, our maximum pressure "inside" mold is about 1.5 bar. As for plastic mold, I don't think they can handle the pressure & heat/cooling multiple times.
@EPSEPP6 ай бұрын
@@MultiKumar321 Usually when you buy those raw material, the provider tells you the density range. There are also phrase of pre-expand and aging before block molding, so there is lots to do actually "control the density". Some extreme case, even when you completed foaming, some clients use hydraulic press to compress and make the block's density higher. Please describe more specific phrase of density you are looking for.
@EPSEPP6 ай бұрын
@@MultiKumar321 We usually use steam as it is most efficient way in mass production, not hot water. If only in small amount, and not density sensitive, (because you are impressible control pressure inside dry oven), then it could be expand. I had never try this before. Beware that you are not possible to expand them and not 'shape' them by 'dry oven' way, you need stirring to prevent them from getting together.
@williamandjacklynnscott53179 ай бұрын
Where do you get these beads?
@makingcookingfixing6 ай бұрын
How would you call these beads as poly styrene beads it seems are nowhere available
@ForPropertyInvestors Жыл бұрын
Would this be suitable up 100 degrees, as insulation around hot water pipes in a car angine bay?
@zachdidat7513 Жыл бұрын
Is that a homework question? It would depend on the thermal properties of the specific type of polystyrene / foaming beads used 🤔
@ForPropertyInvestors Жыл бұрын
Not a school homework question. Just considering ways to insulate/keep hot waste vegetable oil, passing through filters on its way to the engine injection pump, which is better if the oil is gotten radiator temp hot!
@ForPropertyInvestors Жыл бұрын
Considering a copper coil tightly wrapped around a CAV oil filter cartridge and then encapsulated with foam of some sort to insulate it more!
@andreyl270511 ай бұрын
Hello sir. Can you tell me if there should be a hole in the mold so that the water can go in?
@EPSEPP10 ай бұрын
I think Zach put a hole in his mold in order to release the pressure.
@andreyl270510 ай бұрын
@@EPSEPP Thank you)
@saadmahmoudelhwary9567 ай бұрын
Why do some people enlarge it to half its original size, then put it in a mold, then enlarge the foam to the largest size?
@EPSEPP6 ай бұрын
To reduce cost. If this foam product is not sensitive to its density (strength), then make it lighter (each material larger) would be more economical.