Experiment on Single Phase Series R-C Circuit

[@s.dharanidharan8151]

But, sir for every milliampere and resitance there will each black banana connector and has u say if we have different black banana connector across milliampere and resistance,the connection will not be there and there will be no reading at resistance and capacitor

[@ADKTech7]

You can use separate connectors and connect them externally.

[@shankhanaada]

Nice... Very good explanation

[@ADKTech7]

Thanks a lot 😊 Please like, share and subscribe

[@namratadongare495]

A lot of thanks sir .

[@ADKTech7]

Welcome 🙏👍

[@s.dharanidharan8151]

What is the reason that milliampere and resistance has same black banana connector sir Plz answer sir

[@ADKTech7]

You can also use separate connectors. Actually this board was made during covid-19 lockdown. Hence the kit was designed using limited resources.

[@s.dharanidharan8151]

If milliampere and resistance has different black banana connector then what will be the connection plz say sir please sir

[@ADKTech7]

Connect black of ammeter with red of resistor.

[@s.dharanidharan8151]

My teacher told that milliampere should have one black banana and resistance should have another black banana connector sir . This for my project work sir. Plz sir

[@ADKTech7]

Correct, you can use two different connectors for ammeter and resistor. But since ammeter and resistor are connected in series, negative (black connector) of ammeter and positive (red connector) are connected(shorted) together. Hence instead of using two different connectors and shorting them I have used single connector.

[@s.dharanidharan8151]

Sir why millampere and resistance has same black banana connector.

[@ADKTech7]

Answered in the above comment.

[@s.dharanidharan8151]

Sir why there is a no line between resistance and capacitor . I mean that blue pen line sir

[@ADKTech7]

There is no line between resistor and capacitor because they are not internally connected. If you want to perform experiment on pure resistance or pure capacitance separately, they should not be connected with each other.

[@ADKTech7]

Blue line indicates permanent connection.

[@s.dharanidharan8151]

Sir what is the blue wire sir that is connected with ap down transformer

[@ADKTech7]

Blue wire is for carrying 230 V AC supply to the primary winding of transformer

[@rahulpawar3630]

RC series circuit kit kaise banaye uski video banavo please. Or thanks sir

[@ADKTech7]

@Rahul pawar ok👍

[@ADKTech7]

Making RC ckt is very simple. All u need is 1 step down transformer (12v-0-12v or equivalent), High wattage resistance of any value, capacitor used for fan, Wooden or PVC board, female connectors and some connecting wires. Draw circuit diagram on board. Punch holes for connectors. Connect R and C as per shown in video. Connect power supply pin and wires to the primary of transformer and secondary terminals to the connectors. Your circuit will be ready. Try on👍

[@rahulpawar3630]

Thank you sir

[@rahulpawar3630]

@@ADKTech7 sir female connector nahi mil rahe he to Bina connector ke kit bana sukte he kya direct wire leke

[@ADKTech7]

Use banana connectors of 4mm or 1mm. Without connectors connections may be loose and readings may vary.

[@ganeshdahiwade1601]

Can I use bulb in amphere side

[@ADKTech7]

If you use bulb, the bulb will itself act as load. Readings may be wrong.

[@s.dharanidharan8151]

Sir pls answer fast sir

[@ADKTech7]

I hope your queries resolved