F800GS Rear Wheel Bearings Replacement / DIY

[@ikhwanmangsor]

look so easy on how you press the bearing inside. got any tips to ease the process?

[@lorenz987]

Used this for my girlfriends F650ST ‘97, pretty similar. Great walkthrough! I wonder, did you also have a clip on the brakediskside holding the bearing in place and sits between the outer rubber seal and the bearing? Also noticed a washer sitting on the tube in between the bearings. This prevented in my case the destruction of the second bearing as it acted as a shield for the ballbearings from the worn out bearing.

[@aquapoolko]

4:30 I think you made a mistake at this point. The aluminum sleeve should be placed the other way round. The protruding edge inside not outside. I made the same mistake cause it just seems obvious, BUT please see the service manual 😉 I guess the edge should press the bearing.

[@lonelydogadventure3031]

thank you ❤️

[@user-fy7gb2if5p]

สอบถามครับ ตลับลูกปืนล้อหาซื้อได้ที่ไหนครับ

[@lonelydogadventure3031]

ลูกปืนเอาไปเทียบซื้อร้านอะไหล่รถยนต์ครับ ส่วนซีลกันฝุ่นสั่งจากลาซาดา ซื้อ SKF Oil Seal # 30-47-7 (รูใน x โตนอก x หนา) ...วันนี้ ลดกว่า 56% บาทเหลือเพียง ฿88.00 บ.!ช้อปเลยที่ลาซาด้า | s.lazada.co.th/s.8uazC

[@akusins]

Right on time. May be You have SKF part numbers ?

[@johndoe-pm7up]

6204-2RSH 3 for the rear and 2 for the front