Factory IO using Control IO Driver - Box Sorter Program

[@alexanderparedes6450]

Please, I need help with the block programming done in Control I/O of the palletizer.

[@anuradhaedachali]

awesome video! thanks

[@pengyuanxia6607]

could you plz tell me how to sort small boxes from medium boxes?cuz they have a same height

[@Cesar_Sanchez24]

good video

[@thanyaratjanmarn1784]

Hello, I'm from Thailand. Can you do a sorting by height advanced for me to look at, please?🥺

[@anuradhaedachali]

why did you use low sensor and not pallet sensor for latching?

[@williamschwab9216]

The Pallet sensor only gives information that a box is coming. There is no information on the size of the box, when then front edge of the box passes thru the sensors there always is a low sensor which is used to latch the box size. If only low sensor (no high sensor) then it is a small box. If both low and high sensor then it is a large box.

[@anuradhaedachali]

@@williamschwab9216 ok isn’t it true that if the pallet sensor goes off the true sensor will always go off because they are at the same level.

[@anuradhaedachali]

how are you getting the tags displayed when you move cursor in studio?

[@williamschwab9216]

When a memory is added you must click on to highlight the memory, then an address box pops up on the bottom of the screen. Here is where you can add a tag, the address is automatically added.

[@anuradhaedachali]

@@williamschwab9216 thank you!

[@ntombomusimubianda2916]

well done

[@luis-oy9bq]

hola, no me permite guardar ni abrir proyectos en control i/o, pero si en el factory i/o. ¿A que se deberá?

[@sajadsagvand5639]

Hi