Many time a machine will lose it’s home position due to loose wires, battery dies on the amplifier or just plane bad luck.
Пікірлер: 32
@teokovacev45005 ай бұрын
Only difference is that after unlocking 1815 you need to manually go to reference point and then lock 1815. thanks for the vid
@seanmarquez95135 жыл бұрын
Thanks for this, had a battery go bad. God Bless !
@janebibal77314 жыл бұрын
Great help for newbies.
@thomasplante60122 жыл бұрын
Thanks for the help brother 👍👍🍻
@linandy13 жыл бұрын
Thank you ! Save my ass because i didn't order new battery in time...
@ChicoLinguica2 жыл бұрын
Obrigado. Me ajudou aqui no Brazil
@waheedahmed20932 жыл бұрын
Dear sir, Greetings. Thank you so much for a good educational vedio. I have question that what is LSK and how to solve this problem? Thanks and regards
@wmmachine92334 жыл бұрын
Thanks!
@roberttaylor86446 жыл бұрын
Many time a machine will lose ITS home position because of loose wires, battery dies on the amplifier or just PLAIN bad luck.
@gilforin5 жыл бұрын
If it happens every time then battery
@james93114 жыл бұрын
APZ is straight forward, can you do an ‘X’ gridshift video? (Param 1850)
@glennedward22014 жыл бұрын
What was the first button you pressed. Video is blurry I can’t tell what you’re doing
@gilforin3 жыл бұрын
Pos, for position then Off/Set.
@fredrezfield16299 ай бұрын
position reset = return ? ? would this be the same in fanuc 32 i >?
@jared_s23 жыл бұрын
is the bottom row in 1815 for z axis? or does the top row set both axis to home?
@themotofix57053 жыл бұрын
How do you know its 01815? Will all my parameters be listed in the manual? Or how do I figure out which 00000 parameters are which?
@gilforin3 жыл бұрын
Parameter manuals have a description. APZ is for position resetting. Sometimes APC needs to be changed but that is very rare.
@prashantstarapure69693 жыл бұрын
Do video on Vmc axis homing
@markanthonycolorado68514 жыл бұрын
Hi can i ask a question . I already enable the parameter but why the system key is not responding ?? Can you please help me?
@gilforin3 жыл бұрын
Sometimes the it’s protected by a password on parameter 3210
@gilforin3 жыл бұрын
I also had one experience, the soft key didn’t function and I called Fanuc and ordered a new board for replacement.
@vuquynh6166 жыл бұрын
thanhs you
@devendradoddala40905 жыл бұрын
How to enable power monitor please make a video
@abramfriesen98349 ай бұрын
like some help my parameters are all missup the z is a 1 and the x is 2 in Actual position and Machine and Absolute and Distance all 0000
@shadyabdoalrahman12246 жыл бұрын
Thanks please I need home position for turret tools
@chuocheongashtonyewyuanjun1793 жыл бұрын
Bro...why my machine x.y.z can't home...but manual Jog all can running