FANUC RoboGuide Tutorial - DCS Zone Creation | Elite Automation

[@2002Nun-se1ld]

You can input stuff around KUKA/FANUC so won't collide, but must do manual? Can you put an autonomous scan?

[@EliteAutomation]

Fanuc will do the same through DCS. There is a special operation for the robots to not colid though. I believe Collision Gaurd

[@mw3blackopsglitches]

So how do you DCS without Robo Guide?

[@EliteAutomation]

It's in the DCS menus. We can probably make a video on this. If you have the 4D view in the robot it'll make it easier because you can see the DCS boxes in the 4D view. If not then you have to do it by math only which is the way I used to have to do it.

[@pratishmalviya7029]

@@EliteAutomation That would definitely be amazing if you could do that video.