Find out more on FishboneOffroad.com: bit.ly/FB23029F
Пікірлер: 14
@patchrockit Жыл бұрын
My kit didn't come with a traceable outline template. SO, I just flipped my tube fenders upside-down, and observed the underside of the top. I used painters tape to line the underside of the tube fender where the top of the old fender will be, and peeled it off so i had one big sticker. I laid it on top of my old fender, cut around it, and the fender slipped right on, no recutting or trimming, etc.
@Fedichenok2 жыл бұрын
Hi, I installed aftermarket fenders and duo this installing I had to remove stock turning lights. Also I installed new headlights with turning lights as well so tried several combinations with the wires and didn’t get any luck! The lights are blinking like the bulb burned out. Do you guys have any ideas how to get it work properly?
@FishboneOffroad2 жыл бұрын
Problems with blinking usually have to do with a need for a new relay. I would Google: TJ Wrangler Fast Flash
@patrickwheeler88806 жыл бұрын
Where do your turn signals go
@FishboneOffroad6 жыл бұрын
We offer a set of 3/4" amber LEDs that fit into the tube fenders. You can check them out here: www.fishboneoffroad.com/products/pc/viewPrd.asp?idproduct=93&idcategory=59
@cameronfoleyfoley4445 жыл бұрын
What kinda paint did you get and from where?
@FishboneOffroad5 жыл бұрын
Cameron, we don't remember the exact brand. But we grabbed a black can of spray paint and used that.
@JoeL-zr4kx5 жыл бұрын
seems a bit more involved than the video shows. are instructions more in depth ?
@FishboneOffroad5 жыл бұрын
This video is accurate as far as all the needed steps to install. The only difference is that its time consuming to install tube fenders. We increased the speed of the video to show all the steps. Thanks.
@Geraldbux04015 жыл бұрын
where is the turn signal?
@FishboneOffroad5 жыл бұрын
We offer a set of 3/4" amber LEDs that fit into the tube fenders. You can check them out here: www.fishboneoffroad.com/products/pc/viewPrd.asp?idproduct=93&idcategory=59
@FishboneOffroad5 жыл бұрын
We offer a set of 3/4" amber LEDs that fit into the tube fenders. You can check them out here: www.fishboneoffroad.com/products/pc/viewPrd.asp?idproduct=93&idcategory=59
@jlateralus213 жыл бұрын
@drewskie 1996 same TJ hardware? Or did you buy JK signals?