Festo FluidSIM Electro Pneumatic Introduction

[@RM-zx9ee]

Great video! Can you explain why a0 shows up as an NC contact even though you have put as an NO? The electric diagram should show the non energized state, right?

[@TheDeise13]

The normally open a0 switch is pushed close when the cylinder is fully retracted, this condition is denoted by the small arrow to the left of the ao symbol on the circuit diagram.

[@prof.onkarsalavi7143]

This will not give continuous reciprocating motion of cylinder

[@TheDeise13]

Hi, Just use a start switch with detent if you would like to have reciprocating motion.