Festool Live Episode 61 - Tapered Column Build

[@garyknable1155]

Finally not struggling to hear you LOL what a great episode loving it

[@ronh9384]

I was rewatching this video after watching the build series MFT cart and had a question about the sys drawer cabinets that you guys built to replace the metal cabinets that were behind you before. Are you guys doing a Festool Live on the cabinets? If you are not doing a video can you share the dimensions for the cabinets you built please? Thanks for your time and keep up the good work folks. Ron

[@ceyhunatacan5643]

6:32 The angle is 2.75 degrees. arctan(50/1040)

[@thewoodworker106]

Great job. Love my festool tools

[@cleonwalters4093]

You make me smile

[@coleandrews25]

Going to the wide to loose setting , how does that affect alignment.

[@jayrutan3495]

I have a Ten in One clamping system. I've been trying to figure out a way that I can use this with my MFT work bench. Can you help me with this problem?

[@jwar2163]

I will assume that you have this 10 in 1 clamping system shown here in this KZbin Videokzbin.info/www/bejne/gJCqep2lrbqDZ8k . If that is so you can hard mount that system to a 3/4 inch piece of Baltic Birch and clamp that to your MFT with the rail clamps " FS-HZ 160 Quick Lever Clamps, 491594 . Although I have the Festool - SYS-MFT-FX Clamping Set found here kzbin.info/www/bejne/iJemnouca5isi6s For the life of me I do not know why Festool discontinued that kit, but it is still available at some Festool Stores and online sometimes. I purchased two when I purchased my MFTs and I can do almost every thing, but the dowel setup and the high vise of that 10 in 1 clamp system. With some imagination and some elbow grease thrown into the mix I could probably make a jig that would utilize my Sys-mft-fx kit and make a doweling block for rotational work. Your best bet is to make a Baltic Birch jig that will hold your 10 in 1 system to it and clamp that to your MFT top or side rail .

[@kiwdwks]

Nice...thank you!

[@philibertw.ruhmann1604]

Phillip from Lowell,Mass

[@jpcharlebois9681]

Fix the sound on these. They are painful

[@terryfogarty1444]

Informative but excruciating to listen to. Had to mute and just watch the process.

[@mim2046]

You really need to take some suggestions from the guy who does it in Australia. Your side comments/snickering/is annoying to listen to. Fortunately, your videos tend to be informative, but listening to you act like a teenager is really disheartening to the Festool name and annoying to listen to. Your videos would be much more enjoyable to watch if you stop the act and making your videos appear like it is an infomercial.

[@ronh9384]

I hope you aren’t having a bad day....

[@mim2046]

@@ronh9384 not at all. His commentary would be something I would expect from a high schooler and not someone representing a multi-million dollar business. The three stooges remarks in other videos are immature and not very professional. If I acted like him in my live videos I do for my custom furniture/cabinetry business, I would literally lose customers. The guy who does this in Australia stays very professional and stays on point to the products he is talking about. I don’t come onto these videos to listen to someone and act like a young kid.

[@markthorsen3467]

Try the festool international channel. I think it would suit you better.