❶ Festool TS55 Repair 丸ノコの修理

切れるようになったけど、うーん。

[@hokuto59-japanesewoodworki25]

instagram → instagram.com/hokutosekine/?hl=ja

[@TheE9climber]

OMG, you killed me when you pulled out the oscillator 😳

[@ELC.artisans]

Awesome video! Would you mind sharing how you connected the other cables to the engine?

[@olafc91]

This happened to my saw as well, but when I put it together again with a brand new motor housing it was just making weird noises and turned slowly. Any suggestions on what I may have done wrong?

[@LeoNovel]

Awesome job!!!! 👌🏻

[@davemarriott9332]

Exact same thing happened to my TS 75. I’m ordering a new armature. hope thats my issue. My housing wasn’t fried like yours though.

[@felixpeters4953]

He sure don't like any grease on he's hands.🤣🤣🤣🤣

[@ben_philo6583]

is ther not another way to decuntruct than cutting the part? ... i just neet to change a broken part ...

[@lucioaneo7802]

Esta bien wey desde el pincipio eran los carbones, la rompio a lo menso, todavia aguanta el colector.

[@Chroxo]

Did you find the Problem. I have the same problem on my saw. Maybe we can help each other.

[@Yevgen6R]

ok dude, your woodwork projects are astonishing! BUT concerning how you treat your TS55: If you like to resaw !_50mm_! hardwood (probably oak) with "ts55 + fine tooth saw blade HW W48" on 1st and 2nd speed?!!! I have bad news for Г p.s. have you tried connecting this saw with some "flimsy 50 meter power cord extender" and sawing concrete? (probably this type of saw will melt into a puddle) p.p.s translated with google translate

[@Miteltrixel]

OMG This is Festool destruction not repair !!!! are you kidding me. The rotor and stator are going off from the other side. You cant just cut the plastik.

[@derelektromeister6315]

Das schwarze Kunststoffteil zwischen Kommutator und hinterem Lager, sollte sich nicht frei drehen. Es dient als Rückmeldung an die Elektronik zur Drehzahlerkennung.

[@rwinalarwine1141]

I think you will need a new one 😂😂😂

[@user-vd5xi1xx4p]

Надо ротор менять. Сам не перепаяешь.

[@djinaladin2227]

🤔👍✋

[@servistools5691]

😆

[@MG-ti5ee]

Da zahlt man 600 euro , und dann so was.