Fine Material Washer Working Principles - MEKA

Fine material washers, also frequently named dewatering screws are utilized to clean and dewater fine aggregates typically minus 10 mm to fine tune end products to meet specifications and to separate water soluble clay, silt, and micro sized fine particles.
This is accomplished by hydraulic separation; using water to clean and classify by weight. Larger particles (Sand) weigh more so they sink and are collected in the bottom of the trough. They are discharged by steel spiral shaft with replaceable polyurethane or cast steel linings. The smaller lighter unwanted particles are floated to the surface and discharged over the weirs at the lower end of the machine.
Capable of producing high capacities, fine material washers deliver extreme productivity. High efficiency single or dual drives result in low power requirement, thus reducing operating costs while increasing throughput. A large capacity pool and adjustable speed control via sheave changes ensures a steady and consistent flow of fine aggregate peoducts.
Available in both single and twin screw configurations, fine material washers are most often used after a wet screening operation to process products such as concrete, mason, mortar
Specifically, washing is necessary to:
-Reduce the amount passing the 200 mesh/75 micron sieve
-Produce a reliable and constant product gradation
-Remove deleterious material
MEKA
www.mekaglobal.com
MEKA Fine Material Washer
www.mekaglobal.com/en/product...

[@gokhanaldemir813]

Süper

[@bigbird2240]

What does the turbulent flow washing do ? Our screws have normal flow

[@MEKAglobal]

MEKA Fine Material Washers have two sections, feed material and clay are seperated from each other at inclined section under the effect of tubulent flow , at pool area hydraulic seperation occurs at under the effect of laminar flow.

[@emresan8823]

Dip yataklaması sıkıntıları ve rulman ömrü hesaplamasını nasıl yapıyorsunuz?

[@MEKAglobal]

MEKA İnce Malzeme Yıkayıcılarda dip yataklama kullanılmamakta olup, yataklama gövde dışından yapılmaktadır. Rulman hesapları yataklara gelen yüklere göre yapılmaktadır.

[@eduardodaquiljr9637]

The term you use washer is also classifier in gold processing.I think the term here is classifier .

[@MEKAglobal]

You are right this is a classifer use for classifying -1 mm material from sand. In appropriate condtions, it can classify -73 microm material from base material.

[@erayipek2113]

Çok güzel bir animasyon 👏👏👏

[@MEKAglobal]

teşekkür ederiz

[@atefehsaadat2474]

Harika

[@MEKAglobal]

Teşekkür ederiz

[@user-yv6vz1lz4f]

راااااائع

[@MEKAglobal]

شكرا جزيلا لك

[@wazirmohammed1976]

What is the price

[@MEKAglobal]

[e-mail]

[@info_poet]

how much price fore pakistan

[@MEKAglobal]

[e-mail]

[@gulfjobsandsalaryandtips4187]

How much price for India

[@shashacui9423]

nice

[@MEKAglobal]

[e-mail]