FIRST START UP!! on my LS SWAPPED CHEVY shortbed pickup truck!!

well I guess you can say we 89% to being on the road. sent the computer off to get tuned cooling system then drive shaft and we back out hoonin on the streets. if you followed my build from the start then this can be you!

[@diegomercado3110]

Your MAF sensor needs to read air flow through it. It needs to have an air tight seal between you MAF and Throttle body

[@TevionsGarage]

Yeah I figured that out a hour after I made this video lol

[@CatlocosGarage]

Congrats Bro. Another one.

[@TevionsGarage]

I appreciate it my boy lol now gotta slap them twirly boys on the box

[@Swaps-n-Stuff77]

Keep at it ..salute young man

[@edwardmahan1234]

What did you do with the factory computer?

[@TevionsGarage]

put it in the glove box where the factory one went

[@edwardmahan1234]

Talking about the factory computer in the truck not the LS Wiring harness

[@TevionsGarage]

@@edwardmahan1234 oh you get ride of it , don’t need it when you swap the car

[@erikpalomares8533]

Man I need to stop bs’n and get my 4l60 rebuild so I can start putting my 5.3 together for my 89. Bought a short bed as a roller so need to get on it! Hopefully can do a first fire up by next spring

[@TevionsGarage]

Easily could if you follow these steps frfr

[@josenarvaez5338]

Are you able to start the motor without been turned? I wants do mine but everyone is telling me that I’m not going to be able cause it needs to be tuned in order to star up. I know that you HAVE to get it tune. I’m asking about just to get it started to test it

[@TevionsGarage]

Yeah it starts up all I need was the maf sensor put in the right position and it started up with no tune

[@josenarvaez5338]

Awesome. I was looking at your other video “how to clean/cut the harness”. By any chance you know what I need to do since mine is a 2000 (still OBS). And your video is for the 94 obs. Thanks in advance sir.

[@head73bianco59]

Vats delete then you'll be running like a champ

[@TevionsGarage]

Dropping the computer off today

[@kelvincarolinaboilawton803]

Beast Mode

[@Tyvi_24]

Real camera man work🤣

[@TevionsGarage]

Naa your fired sorry I been meaning to contact you via email. Don’t bother showing up tomorrow

[@2jz_ripsiul496]

Sell me that truck lol

[@TevionsGarage]

Don’t think I can do that sir lol

[@Alx_5.7]

How you end up wiring your fuel pump to the stand-alone

[@TevionsGarage]

there’s a fuel pump wire you connect straight to the gray wire on the stock harness. And the bp harness fuel pump wire is already ran to a relay

[@richodd2292]

does the 4l60e bolt up to a 5.3?

[@TevionsGarage]

Yes suh

[@richodd2292]

@@TevionsGarage thank you, no spacer needed or the other stuff i been reading about?

[@TevionsGarage]

@@richodd2292 you only need a spacers when using older style trans,

[@richodd2292]

@@TevionsGarage thanks