Evinrude E Tech 75hp-115hp Trim And Tilt Seal Replacement

#EvinrudeETech #Trimandtiltrepair

[@garymorken1496]

The end cap is designed to open those check valves in the piston, so if the cylinder goes all the way up and the operator doesn't release the switch, it prevents over pressurizing the cyl and causing damage to the system. The new cap without the groove is for a newer system that uses an electric limit switch instead of the mechanical design that you have.

[@shanevincent1000]

Thanks for the video. You totally helped me fix my power trim just in time for the 4th! Thanks again! Bass & Grass!

[@SpeedingTube]

Great walkthrough, thanks 😎👍

[@davidtaylor7875]

Brilliant Vid. Thinking about doing this job..very well explained what you did Thanks.

[@werftv4580]

keep working on it, man.. we're still here

[@youngevans81]

Glad it's fixed!

[@richarddiaz8248]

Thank you for your time

[@baboy_3420]

Nice❣️

[@garyncorbett]

Did removal of that pin on the top of the piston cause problems later for you?

[@kenmoses8]

I've seen others replace that end cap with the wrong one in other videos, and i just found out mine has been replaced as well with the wrong one. Its also missing one of the four bearings :( Is the correct end cap with kit available anywhere without having to buy an entire unit?

[@bryang4323]

Where did you get the seal kit from. I need one myself exact same issue 90hp

[@garyncorbett]

I ordered the cap with no groove- was this wise?

[@moparmadman1134]

How bad does shaft need to be to tear out seal .Can see a couple of marks on it just feel something slightly

[@sjcumpsty]

Do you know what year of etec this is for. I have a 2009 that is leaking badly. Dealer tells me it can’t be resealed. But Amazon has the seals and tools.

[@sheiladenoncourt9946]

Did you ever have any problems with the new cap with out the groves?

[@BASSNGRASS]

Not anything that I have noticed

[@lawnchair101]

What is the part number for the smaller spanner? I'm guessing it's the 31mm...thanks!

[@sheiladenoncourt9946]

mt0009 35L

[@douggemmill3497]

Where did you order the kit from?

[@ayhankucukozer1478]

Hello. We changed the e tech 25 hp petrol pump. but everything works normally, the energy comes, the pump works, but the engine does not start by gurgling.. we spray the cylinders with lining spray. Hello..

[@rkingeco-bincleaning3078]

Where did you order the seal kit?

[@daveperryLXXVII]

Just changed my neighbours one. Still pissing fluid out the top like crazy. No idea what's going on

[@garyncorbett]

I left a couple questions/ hope you get on here to answer them

[@GringoSF]

Good video, I'll ask you. I have the same trim on an evirude 90hp, etc. When I'm in the water and I compensate with the trill and I leave it after a while while sailing, it goes down on its own, which could be

[@alanburke758]

I think the video which is terrific finishes prematurely. Am l correct

[@goinginsane37098]

Yes. We don’t know if it worked after he got it all back together

[@Cotton603]

You “think that will work” then end the video lol DID IT WORK OR NOT?

[@Grip-n-Rip-It]

Most stressful video I've ever watched.