poor servrs..hihi(k niw oeivken of direct translate
@obregr5 күн бұрын
and consuder to buy or make filement dryer,because unfortenly is thet you need at ,a lot of filemet are moister abovsourbers,
@unnameddev11925 күн бұрын
Yeah good point. I thought about getting one, but it works where I have it right now. It is a cold room that is always at the same temperature so perfect for the 3d printer. But if this happens more often I will definitely buy one.
@unnameddev11925 күн бұрын
I also thought about getting a new 3d printer as mine is quite old right now. I kinda like the bambolab printers because they are really fast but reliable. Might get one in the coming months. Also I might make a stream this weekend if I get everything setup on the arm. It would be a programming stream with a lot of testing so probably quite fun to watch how I destroy the arm while testing it XD
@obregr5 күн бұрын
@@unnameddev1192 this is har to achive you have winter summer,i will have 3d printer in the basement,and there will must have ,you can diy one
@obregr5 күн бұрын
@@unnameddev1192 but bamboo are expensive one,bu as i lok at they arent perfect eather bad