Flow master 50 install on FJ Cruiser

[@MrPallwaul]

I’m I weird for thinking the no muffler sounded really good?

[@amandagoehring8110]

Sounding good

[@rafaelsegura8333]

I’m trying to buy the same one, it’s that 2.5 in and out ?

[@Jay-rg5mt]

Do you have wheels spacers on or your wheels just offset?

[@mattgiorgi7507]

Yes I do

[@kealahau6727]

Remove rear cats...

[@anavan7]

Couple of questions. Did you lose any back pressure with the flow master 50? I assume its quicker on the low but not at high rpms? Also did you use JB Weld on that and if so is that safe due to high heat? Sorry for so many questions just curious on doing this diy with my fj.

[@mattgiorgi7507]

I can’t say for sure but my butt dyno felt more low end and yeah little less up top but nothing noticeable! No if muffler cement to seal any miss spots while welding! This was a temp fix I redid this in a later video check it out