Flow over a cylinder (part-1) Mesh generation using ICEM CFD

[@ErmElsa]

Fantastic video, can't wait for part two.

[@shahabanwar6280]

It would have been so much of a help if you had provided some audio too. :|

[@channelwanderer9920]

thanks! it's so helpful to me!

[@abhishekpanjiyar8266]

We do this to improve the quality of mess i guess.Please also give concept for 3d modelling if possible.Thanks

[@fathanlewenussa5026]

Can this generation used as a friction stir welding?

[@footballmagic9996]

Can we use this mesh generation for unsteady laminar vortex shedding simulation

[@oliverwijaya1525]

do you have tutorials for meshing 3d cylinder

[@abdomostafa5775]

How can i export this mesh file in ascii format from icem

[@fauzansahdi1654]

Thanks for the Video. I have 1 question. When I got to minute 6.10, I tried to perform the same procedure you used to delete the premesh in the cylinder. Instead, only the mesh in the square box within the cylinder is deleted. Why is that?

[@jparun36]

If the block which corresponds to the interior of the cylinder is not deleted, then the mesh is generated within the cylinder(as you can see 6:04). Actually, we don't expect any flow inside the cylinder. So, there is no need for that block.

[@ritumaurya8979]

Exactly...

[@TheViniZM]

Where is part 2?

[@dayiwang4613]

Nice video mate, can I ask one question about the spacing? So if I download an airfoil data without dimensions, and using y+ to calculate the boundary layer spacing in meter, do I need to multiply the result by 1000 to make it becomes millimeter, or shall I just keep what it was? Thanks! ;)

[@MohitSharma-uq2vm]

Hello ritu ..i'm on CFD modeling of solar still in Ansys workbench ....i need some help in improving mesh grid ......

[@abhishekpanjiyar8266]

Please send the file if possible I am working in ansys18.1

[@sarrahabibes4373]

I need someone to help me to apply structural Mesh Anyone who knows the ANSYS fluent well helps me Thanks❤

[@FarhanKhan-hr5zj]

Yes, what kind of help you need.?