Focus ST Thermal R&D turbo back exhaust before and after Vibrant ultra quiet resonator install

Last fall I upgraded the downpipe on my ST to a Thermal r&d high flow catted unit, and it was a little too loud. I installed the Vibrant 1142 ultra quiet resonator and brought the exhaust note back down to, or a little quieter than, what it was with the stock
downpipe. heres a comparison.

[@iguardwisconsinberry8830]

Sorry I'm just a tad bit confused here. Would I remove my cp-e resonator and replace it with the ultra quiet one or make it an addition to the cp-e resonator? Thanks man, still new to exhaust as well lol

[@GTkyle]

Add it in addition. Its small enough that you (or your local exhaust shop) can cut and weld it in somewhere between the existing mufflers and bends.

[@iguardwisconsinberry8830]

@@GTkyle where did u put yours at exactly?

[@GTkyle]

@@iguardwisconsinberry8830 well, my thermal exhaust doesnt have the flange placement of the stock exhaust so i stuffed it in the downpipe. I'm unsure of the exhaust routing of a fusion, but if you buy the resonator and take the car and resonator to a local exhaust shop, they'll figure it out.