FOR THE HUNDREDTH TIME

[@SackettGems.]

Great video, always wondered if the hundredths on most diagrams (and some machines) were there for true accuracy or simply the illusion of it. Keep up the good work!

[@rimereit]

This was very helpful, thank you. I actually feel relieved now.

[@rebeccasherry1769]

You're the best I'm so glad you put out a new video

[@ismaelo73]

I was able to reduce the flexion on UT VL by rolling a little piece of Teflon tape around the height adjusting bolt.

[@evgenyk.4681]

Hello, John Nevertheless, if u are cutting your gem with UT v5 using a soft stop, it works well with 0,01 U get absolute presise meet points... But after transfer, u get probably a tiny error with meet... If u use other machine... or v5 with hard stop, u will never get the 0,01 precision 😊

[@danielyork3406]

im actually looking at buying a copper lap for rough grinding (like 100 grit or so). Do you have a recommendation of a good site for a good copper lap?

[@gemstoneartist]

I don't have a specific supplier of copper laps that I like. The last one I bought was from Gearloose, but he doesn't make them anymore. The real issue is flatness. And, if they're bonded e.g. to an aluminum master - that the bonding technique remains stable across time and temperature changes, etc. I'm finding sinc a much better material for pre-polishing, as copper has a higher friction coefficient (more likely to produce orange peel). And, the zinc are also more available in the market. Maybe this will be useful to you...

[@johnhodgson4216]

The lap itself is variable, I have ceramic laps which have a higher accuracy of flatness, the most accurate lap I have is an Aluminum Oxide Lap, and it's machined, I am making conical shapes, so the amount of material in contact with the lap is the min amount. the variance if the diamonds is the issue. For me I am not making the flats, and its nice to know that the pressure and quality of the lap really matters.

[@HeliosFire9ll]

Can this dial indicator be fitted on a Seatle Face-ette?

[@paraglidingklamath]

Sure. The connector attaches to the dop. Anything with a 1/4 inch or 6mm dop will work with this connector shown in the video. If you have a different sized dop, just search out a different connector to hold the dial.