I have the exact same 4000 and need to do my seal. I will press the seal in with a shop press though. Thanks for the vid clip !
@flipflopsgarage2 жыл бұрын
Shop press is the way to go.
@arra34109 ай бұрын
And that is why I decided to make a 20 ton bearing press
@dampflieger Жыл бұрын
Thanks for the video. From the type of snap ring that you have (with eyelets) it looks like the shaft has been removed and the snap rings replaced.
@flipflopsgarage Жыл бұрын
That’s very possible as old as these tractors are. I’ve found some funny fixes from some previous owners.
@dampflieger Жыл бұрын
@@flipflopsgarage Same on my 68 Ford 4000, course I cannot complain too much as my father in law bought it new the same day my wife was born (You can see his priorities). So I can trace back every issue that comes up to the original "fix". I did manage to get all the bailing wire off of it though :D
@275Vet-RLTW2 жыл бұрын
If you do have to pull out the shaft for any reason if you engage the pto before pulling out the shaft the slip ring Won't drop.
@flipflopsgarage2 жыл бұрын
Good information to have thanks.
@edmundmaher4632 Жыл бұрын
HI would I need to have the tractor running while engaging the pto clutch (independant type) as my thinking is the thrust washer is then sandwiched with pressure on the clutch plates