Ford Ecoline E Series Van Cluster Cloning/Swap/Programming with Autel IM608

[@alexagyemang7546]

Best programming instructor ever

[@artem-avtodiagnost9660]

Hi. you explain in great detail. perfect 👍🏼 I will watch your channel because i bought im608

[@MustafaMustafa-kw2ji]

How much you bought the IM608 and what accessories you also bought with it to enable programming. Thanks

[@best_technician]

Very good information thanks you

[@julioalay7004]

Amazing job keep it up

[@moonslivers]

Hi, great video. Question: Have a 2008 f350 that I installed a new SJB on. Used Ford IDS to do programming. Everything seemed to work well. Noticed a DTC in the cluster module (IC) and switched to ForScan w/ vLinker. Noticed the as built data in the IC didn't match the motorcraft website so I wrote the data from motorcraft after backing up with forscan. Immediately after writing truck went into any theft mode and cannot communicate with any modules. Think it was because I unmarried the cluster. Have a 908s elite II pro coming. Do you think I can restore the cluster w/ eeprom programming like this? Any thoughts appreciated and happy to pay for time and thoughts. Ty

[@mynty2864]

how do you know what you're doing? are the instructions in the diagnostic device?

[@shontaylor9931]

Agreed! i have a 608, wan to learn how to perform this on japan vehicles.

[@nathancriswell9289]

Can you just solder the old chip onto the new board???

[@mtberguy]

How did you figure out which chip to go to?

[@huyug1]

It will require bit of knowledge about MCUs before hands

[@mtberguy]

@@huyug1 I’m starting to get into the eeprom world and that’s been the biggest mystery to me so far is how to know which chip to go after.