Ford jubilee brake and hydraulic repair. I finally finished it

[@darrelfuhrman8217]

I have an NAA. I use Cenex’s HTB, a hydraulic, transmission, wet brake fluid in my transmission, hydraulic, rear axle. Hello from north east Montana. 10 miles from the Canadian border.

[@neelcyr9714]

Nice workup on the brakes, the only issue I can see is working under it with a HI-Lift, I had a jack slip out on me, at least put the wheel under the transmission so if it does slide out you have about 12 inches of safety.

[@4cfarms853]

You are correct about high lift jacks. I'll go as far as to say that the front wheels were thoroughly chocked and a wiggle test was done. I probably should have included that in the video! Thank you for the feedback, it's always appreciated.

[@robertpsarudakis3474]

Nice work! My dad has '54 NAA, did brake job, transmission fluid, I fixed the original Vane HY-Trol Pump with new seals.

[@alk5749]

That brake tool works fine if you use it right, I watch young people work on stuff, never clean your work. How long would it have taken to clean up that hub ? 5 minutes. Take pride in what you do, even if the customer doesn’t.. I guess over my 75 years we just learned to do things different. An honest days work for the pay we agreed to work for.

[@jonmonie6342]

Why bother to clean it up. The axle seal was pouring oil out. I agree with doing a nice job but not with purposefully engaging in acts of futility.

[@patkearney4644]

Sure helped me identify where the drain plugs were as well as the filler cover.

[@4cfarms853]

It's always great to hear that I have helped someone! Thank you!!

[@kevinpaulson2659]

That was very informative. Thanks!

[@philescobar5607]

If that jack slips??? Bad day!!!

[@lynnmackenzie9501]

Nothing like putting new brake shoes on a leaking wheel shaft. It will be all screwed up in a short time.. Grease and oil dont go well with brake shoes.. I wouldn't do a job like that..

[@jonmonie6342]

You missed the part about that being what the customer wanted.

[@bp-eu6sh]

your damn throttle needs a NEW spider spring/friction plate ... easy fix if you have common sense

[@4cfarms853]

Not my tractor. Not what I was hired to work on.