Ford Ka (2008-2016) door panel removal

Due to the fact that the window regulator broke, I had to open the door panel to have access inside to be able to install the new regulator. In the next clip I try to describe as much as possible how to remove and and how to reassemble the dor panel.

[@cphild9256]

Thanks so much... very helpful 😊

[@PAFixandCrafts]

@cphild9256. First of all, thank you very much for your comment!!! I am very happy to know that you found my video helpful. Don't forget to subscribe to the channel if you haven't already. This will motivate me to continue and add more videos like this. And if you have questions, don't hesitate to write to me.

[@nandoarnaldo7400]

Excelente video . Tengo problemas con la cerradura derecha . Siempre queda abierta . Gracias desde Argentina.

[@PAFixandCrafts]

@Nando Arnaldo. En primer lugar, gracias por tu comentario. Estoy muy feliz de saber que te gustó este video. Si encuentras útil mi canal, no olvides suscribirte. Esto me anima y motiva a publicar más videos.

[@gyetvaimarcell]

Hey! Can you help me? I broke the white 'handlebar' you first remove out when shutting the door to make sure its well shut. Well, it broke at the middle screw (where your elbow rests). So the handlebar is intact but it brokr out from the door. Is it possible, that I need only a scrw or pin OR i need a complete 'handlebar' with the door opener?

[@PAFixandCrafts]

@gyetvaimarcel. First of all, thank you very much for your comment! The door opening device should be a separate mechanism that does not influence this situation. However, it is quite difficult to break from the screw. Maybe it was not tightened well or it came apart in time. It is quite difficult to give my opinion if I do not see what it is about. If you could send me a picture, it would help me understand the situation better and maybe we can find a solution together if you haven't succeeded so far.

[@Alicia48818]

Hi, do you have any video on how to remove the plastics on the back to change the speakers? Thanks

[@PAFixandCrafts]

@Alicia48818. First of all, thank you very much for the comment!!! I performed this operation once before, but unfortunately, I didn’t film it at the time since it was before I started uploading videos to KZbin. I do plan to remove the rear part again soon, as I’m also dealing with a minor issue-a speaker that’s distorting. I’m not sure if there are particles on the membrane or if it needs to be replaced. So, I’ll need to open the back again, but I can’t say for certain when that will happen. But what I can promise you is that I will write to you when I upload this video! If you found my anwer helpful, I’d love for you to subscribe to the channel if you haven’t already. Your support truly motivates and inspires me to keep creating content!

[@Alicia48818]

@@PAFixandCrafts Thank you very much for your response! I also need to change the speakers since I think they are broken and they sound like plastic when I play music, I will be attentive!

[@ruthjeavnon]

Hey! Thanks for the video, i have a problem with my doorhandle on the outside, i have to pul very hard and fast and than it will open, do you have any idea wath the cause is, i thought maybe the handle is not connected good on the inside.. do you have any ideas? 😊

[@PAFixandCrafts]

First of all, thank you very much for your comment!!! Unfortunately, I can't figure it out, but for sure it must be a loose screw or a broken guide. I would really like to help you, but without opening the door and looking inside, I can only give my opinion, but that won't help you much. If you are from Bucharest, I could look at the car one day. If you have found the information provided beneficial, I encourage you to consider subscribing to the channel if you haven't done so already. Your support serves as a significant motivation for me to continue creating and sharing valuable content through future videos. Thank you mery much!

[@KazunaiOwO]

Hello, do you remember what screws they use to hold the speaker in place? Thanks!

[@PAFixandCrafts]

@nekokun!. First of all, thank you very much for your comment! Unfortunately, I didn't pay attention to the speaker, so I don't really know what screws are used. But soon I will open the back of the car because the rear left speaker has a strange noise at a higher volume. In this way in a few weeks I can give you an answer if it is still helpful. My answer probably didn't help you much, but if you want to help me too, don't forget to subscribe to the channel. It helps me very much !!!

[@KazunaiOwO]

@@PAFixandCrafts Thank you for your answer, i will open it this week so theres no need. But thanks anyway!

[@KazunaiOwO]

Turns out they pop nailed them in place, had to use a drill to get them out.

[@PAFixandCrafts]

@@KazunaiOwO Thank you very much for your reply. The vast majority of newer cars use these rivets. I just wanted to ask you, why did you have to remove the speaker?

[@KazunaiOwO]

@@PAFixandCrafts I wanted to upgrade the speakers, i put in jbl club 622 speakers and a pioneer subwoofer.

[@michahg3206]

nice Ok !!

[@PAFixandCrafts]

@michahg3206. First of all, thank you very much for your comment!!! Don't forget to subscribe to the channel if you haven't already. This will motivate me to continue and add more videos like this. And if you have questions, don't hesitate to write to me.

[@Crullors]

Where Can i buy Those orange tools you Got to Remove the handels

[@PAFixandCrafts]

@ludvig86. First of all, thank you very much for the comment! These were purchased by Aliexpress and cost around 7 euros, but I saw that they can also be found in most supermarkets in the car section. Ordered from China, they are cheaper, but you have to wait about a month for delivery. In the supermarket, they are about 14 euros, which is double, but the advantage is that you can have them immediately. I hope you found my answer helpful and if you have other questions, don't hesitate to contact me.