In This Episode I Make the Forward & Reverse Lever Support Bracket EP10 #Machining #Stuart 10v #Steam Engine #Milling #Steam Ports
Пікірлер: 18
@djhscorp4 ай бұрын
Always interesting to watch.
@EnglishHobbyMachinist4 ай бұрын
Thank you
@mikechadwick33404 ай бұрын
Nice one Mark, looking forward to having a go at this piece . Thanks for the video.
@EnglishHobbyMachinist4 ай бұрын
When you get to this part, use a rotary table if you have one, I got a bit lazy and didn’t want to setup the rotary table but wished I had, halfway through 😂
@nobbysworkshop4 ай бұрын
Some great set-ups there Mark. I'm learning some useful tips from you. ATB Cheers Nobby
@EnglishHobbyMachinist4 ай бұрын
Thanks Nobby 👍
@mikechadwick33404 ай бұрын
Thanks will do
@gregwmanning4 ай бұрын
Welldone, that was a very fidderly piece
@EnglishHobbyMachinist4 ай бұрын
Thank you 👍
@joell4394 ай бұрын
👍👍😎👍👍
@EnglishHobbyMachinist4 ай бұрын
👍
@RB-yq7qv4 ай бұрын
@memememe26744 ай бұрын
I know it's your choice, but I have seen you you a rotary tab. Why not use that much easier
@EnglishHobbyMachinist4 ай бұрын
I got lazy 😂 and couldn’t face taking the vice off, aligning the table and then putting the vice back on the mill, for what appeared to be a small job! As it turned out, it took twice as long 🤦♂️ moral of the story, don’t be lazy!😂😂
@paulrayner45144 ай бұрын
I assume you haven't a rotary table?
@EnglishHobbyMachinist4 ай бұрын
I have 2 rotary tables but decided to do it this way! but wish I had used the rotary table by the time I was halfway through 😂
@paulrayner45144 ай бұрын
@@EnglishHobbyMachinist Ok. must admit I was expecting it to come flying out of the 4 jaw, especially with it being soft ali. I was clenching my buttocks for you! well done👍