Thank you so much. The washer is the whole reason I watched the video. I took mine apart and things stuck and the parts flew everywhere when I pulled it apart. I didnt know where the washer went.
@toejoe48835 ай бұрын
The cover is binding the bottom shaft. New gasket with rtv and half ass crank the bolts down. Use blue lock tight if worried about bolt coming loose. Even with upper gear out, you can't turn the motor with a allen wrench.
@jayneely3987 жыл бұрын
okay the shim washer is on the wrong shaft it actually goes on the outside of the lower shaft ( not the midshaft. it is clicking the solenoid and putting voltage to the starter. However, you have the midshaft in a bind causing to much load for the starter to function.
@lloydstrahan67055 жыл бұрын
Believe it or not, it is actually the cover binding the gears. I had the exact problem and after a lot of headache I figured out it was due to the gasket being old and crushed. It allowed the cover to tighten down just enough for the posts to bind. New gasket will fix. Mine was doing the same, drawing the battery down to as low as 7v. Loosen pressure and only drops to about 11v and starts right up.
@WVgunfun5 жыл бұрын
Never would have guessed that, thanks!
@darrenbice42282 жыл бұрын
I hope this reaches you, 3 years laters and you're still coming in clutch man 😂 I also would have have figured this out
@daviddunn58697 жыл бұрын
for anyone watching this video ive had the same problem on my honda to save money i tapped the starter a couple of time with a hammer and it lasted another 3 years i know starters are a good amount of money so hopefully that saves yall money
@raceymugg7 жыл бұрын
Mine is doing same thing, what's the problem..??
@brentbrooks36636 жыл бұрын
I've got the same exact problem with my 300 4x4 fourtrax, the kick start never turned the engine over since I bought the machine second hand. So just used the starter, but now all of a sudden I have the same exact problem as seen in this video.
@keithcharles66825 жыл бұрын
Brad B did you ever fiend out why the kick start was not working I got same issue
@charlesehrenhaft40235 жыл бұрын
Im having same problem with my 96 honda fourtrack 300 two wheel drive and my kick start just recently went out seems like it's free spinning when I kick it any ideas i try hitting starter with hammer
@braylenbarcley7737 ай бұрын
You have to replace the centrifugal clutch
@dickkbailey81192 жыл бұрын
Did you ever figure out what was wrong with it
@jasonfrazer93696 жыл бұрын
Use kickstart then it stul be good after that
@michaelkent27976 жыл бұрын
U put the washer on the wrong shaft and the bushing need to be replaced
@carterbikes51777 жыл бұрын
mine does that too and I don't know what is wrong with it
@kennykillingsworth87636 жыл бұрын
Carter bikes dis you ever figure it out
@saucyasf6887 жыл бұрын
change out ground wire to ignition coil
@keithcharles66825 жыл бұрын
I’m having the same problem did you fix yet let me know what it was
@WVgunfun5 жыл бұрын
Yeah I fixed it, I sold it as is.....sorry buddy, might find some help in the comments.
@boykim145 жыл бұрын
just hit or tap the starter a few times with a hammer or something made a metal while pushing the start button and it will start right up
@jerrypruitt74322 жыл бұрын
you put the washer on the wrong shaft. its holding the starter.
@kalikfixes50336 жыл бұрын
Just hit the starter a few times and it should start like my nahigber had same problem
@jaydenwilliams74277 жыл бұрын
I'm pretty sure it's the brushes in your starter I had the same problem with my 350 just take the starter off take it a part and if it looks burnt out go to your local bike shop and pick some brushes up should only be a cheap fix