I did this last year. Went to nationwide chain store and asked for a rag joint, guy looked at me like I'd just sprouted two more heads. FYI, there are 2 sizes of rag joints used in Fox Mustangs, most common is the large one. My '82 used a small one. I didn't loosen the rack as my steering column shifted freely.
@mustangstuff72132 жыл бұрын
Did the lmr one fit properly for your 82?
@bradmaas68752 жыл бұрын
@@mustangstuff7213 Sorry, not from LMR, another vender. First one I got was a large one, second one that fit was about 3/4" smaller
@jytux90145 ай бұрын
Amazing video as always! I would have loved to see the steering wheel play after the install, maybe next time!
@latemodelrestoration5 ай бұрын
Thanks! It was difficult to capture. Honestly, the play looked identical on camera. You could definitely feel the difference, though. -Landan
@JesseAndMike2 жыл бұрын
Liked! Awesome vid as always!
@Raptor33886 ай бұрын
Never had to loosen the steering rack for this job, it's easier to loosen the steering column. I've done that job four times at least...
@leonardcrisci72542 жыл бұрын
Nice Right in time
@jucedcustoms22742 жыл бұрын
Great video!
@codylink Жыл бұрын
Is it ok that your bolts were too short? Did you have to crank the nuts down super tight to get full thread engagement or am I missing something?
@latemodelrestoration Жыл бұрын
Once you tighten the nut, the last thread cuts into the nylon collar. No, they don't have to be crazy tight. Unfortunately, the thread engagement wasn't shown. -Landan
@perkinsservices2870 Жыл бұрын
This video took me too long to find! It looks like it would work on my pinto . Except the removal process is more tricky..
@chrisike-gq8sm Жыл бұрын
Can I put the car on’s ramps or does it have to be jackstands?
@latemodelrestoration Жыл бұрын
It would be much easier if the weight of the car was off of the front suspension -Landan
@MikeCheck-u1z Жыл бұрын
Mine was not that simple and even at the end i couldnt get the splined parts to go on all the way so i had to tighten it on only the first set of splines i also had a different rag joint part mine had rivets in the new one already
@shootthemoon954911 ай бұрын
I hope you're joking.
@stmichael46552 жыл бұрын
my 93 must be diff...couldnt get rack pulled forward enuff on driver side "Hyd lines" and BOTH of my studs are the same size...I would have been better off not drilling them out n leaving them and just use the rag joint n thrown the rest n my bolt bucket. Now I have find a sleeve for the smaller diameter stud and bell it out to retain it....update..leave it alone....it actually makes it easier to access pinch bolt
@codylink Жыл бұрын
Does "n" mean "in" or "and"? I might be having the same issue but I can't understand you