FP dishdrawerv4 F1Code

[@mattmogan7747]

Thank you so much I put dishwashing liquid in and the flood sensor went off on both drawers after following your first instructions and removing bottom drawer and lightly wiping the sensor hey presto both drawers are working thanks for saving me $200 bucks mate your a champion

[@yburblue5307]

matt mogan - omg! What I did to our dishwasher juz now and I can’t figure it out! So I juz turned d main switch off and left the house to unwind huhu. While driving , I thought of watching KZbin! I’m going back home now! Haha! Will keep posted !

[@mattmogan7747]

ybur blue good luck buddy

[@yburblue5307]

matt mogan - can’t open the drawer tho! Huhu I will end up calling d service provider . Sigh 😔

[@SeanArcherSDA]

BAM! Thank you so much for this upload, I dried the base and let is sit there awhile to make sure and it all works now :)

[@jackgoodfellow7283]

Thanks man you repaired all my dishwasher

[@fredvekeman7522]

Thanks heaps, still valid info 5 years later.

[@jansb984]

I have been away for 3 months so dishwasher was not used but remained connected to mains power; 3days following my return but still not using the washer, the beeping noise and F1 fault on the display appeared. I cycled the power with about 1min delay and it was all good for about 20 minutes then F1 returned with beeping. This time I have recycled the power again but I set it on the 7min rinse cycle. No problems after that.

[@YasmelFernandez]

How the heck do I remove it, it won’t come out

[@rodneysmart9774]

Lots of useful info, thank you.

[@tvalenzuela1989]

Very helpful! Thanks so much!

[@MrSoden1947]

when i press the 2 buttons -start and lock - i get a a numbers countup -then F1 + that loud noise CAN YOU HELP PLEASE there is no water in around actuator switch/sensor

[@tehoutimoteo1817]

how do you remove lower draw,mine is stuck.

[@sarvash34]

Very helpful, my problem is solved.

[@ralph9987]

what if both draws have the F1 code?

[@tlb8647]

When you turn it goes To dictate and beats

[@a.hernandez5669]

Mine had been doing this for 4 days.. Power button had nothing to do with this.

[@Ornacia29]

What causes the f1 fault code

[@YasmelFernandez]

That is my problem please someone respond fast

[@williamh9288]

Thanks!!!!!!

[@helencherub3449]

Try turning off at wall. Wait 3 seconds. turn back on. Should reset it's computer :)

[@aussiegrace]

Hahahahaha nope

[@cat48155]

what a shit dishwasher

[@AIMANNY]

sorry hear that. This is help video not sale pitch.

[@gertsy2000]

We've had ours for 16 years. still working fine.

[@arpitashrimali1044]

Utter nonsense

[@thecast7293]

Thank-you for posting this video, very helpful, took me a while to figure out how to get to the diagnosis mode, I found I had to hold down lock button for a second before the pause/start button. Also had to look elsewhere to find out how to remove drawer by pressing in plastic clips as this was not shown in the beginning of your video. Thanks again