Freecad For Lasers Pt 2 - External Geometry and Subshape Binder

[@777smitty4]

I have watched a lot of videos on free cad but yours are great because you go slow and give examples I would enjoy a full class from you thanks for all your time and effort !!

[@jcarolinares]

Man, amazing channel and teacher!

[@michaelluger2127]

very well done -- i appreciated that 'clone' click as much as you did... 'nice' :)

[@9keepa]

Nice. Good. Thanx. I've been thinking about how to do this for a long time.

[@freedoompictures6839]

Thank you!

[@imadog131]

How would I rotate the base to say 30 degrees instead of being flat?

[@thesystemsucks]

great video thanks

[@verdemis]

Why does this channel only have around 700 subscribers... just why? That feels just wrong ...

[@sebsteble2953]

Really great videos. Thank you. Just one question. When the pockets are not in the middle, but right on one side, I have to trimm the side, which leads to loss of several constraints - do I do something wrong?

[@TorontotoollibraryIRBE]

Hey there! Most likely you would be losing a "vertical" or "horizontal" constraint when you use the trim tool. You see when you cut a line, the software makes a decision on which resulting line segment should get the constraint that used to be applied to the full line. So you may have to apply that constraint to the new section of line created by the trim. Also, you may need to apply vertical/horizontal to the points of your corners to ensure they stay aligned.

[@sebsteble2953]

Thanks for your fast and valid answer. Appreciate your videos a lot. Regards from germany.

[@imadog131]

How would I rotate the base to say 30 degrees instead of being flat?